Vélez-Málaga · Costa del Sol

Keep your
protection
performing.

Technical maintenance for ceramic coatings and PPF, plus paint decontamination, so your protection keeps working like day one.

Check your protection Explore maintenance

Protection doesn't end on installation day.CERAMIC / PPF / DECONTAMINATION

Check

We check the real condition of your ceramic coating or PPF before we begin.

Decontaminate

We remove iron particles, tree sap, tar and other bonded contaminants.

Restore

We bring back hydrophobic performance and the original gloss.

Extend

We apply what's needed to extend your protection's lifespan.

Protection doesn't end on installation day

Maintenance is part
of protection.

A well-maintained ceramic coating or PPF performs better, for longer. Periodic technical maintenance preserves its properties and protects your initial investment.

Two ways to care for your protection

Decontamination and maintenance.

01 / SURFACE

Paint decontamination

TECHNICAL PROCESS

We remove iron particles, tree sap, tar and other contaminants bonded to the paint through a technical decontamination process, leaving a completely clean surface ready for protection, correction or specialist maintenance.

Chemical and mechanical decontamination matched to the level of build-up.
A surface prepared for protection, correction or maintenance.
Recommended before renewing a coating or checking a PPF.
A safe process that doesn't damage the paint or existing protection.

Recommended frequency depends on where and how you use the car.

Discuss decontamination

02 / COATING AND PPF

Coating and PPF maintenance

TECHNICAL FOLLOW-UP

We carry out technical maintenance on ceramic coatings and Paint Protection Film (PPF) to preserve their hydrophobic properties, gloss, clarity and protective performance.

A review of the coating or PPF's real condition.
Restoring hydrophobic properties and gloss.
Removing contaminants that build up with use.
Specific treatments to extend performance and lifespan.

Maintenance doesn't replace reapplication once a product reaches the end of its life.

Discuss maintenance

How often is maintenance needed?

It depends on the product, how you use the car and where you keep it. At your check-up we'll give you a guide frequency and the signs that tell you it's time.

Certified CARPRO installers, with internal records for every treatment.See the certification

SW Studio technician checking the condition of a protection before maintenance

Before we act

We check the real
condition, first.

Before recommending any maintenance, we assess how your coating or PPF is really doing: not every car needs the same treatment after the same amount of time.

Condition of the installed ceramic coating or PPF.
Level of contamination on the surface.
Areas with greater wear or loss of properties.
A recommendation for decontamination, maintenance or renewal.

See the maintenance services

Technical check of a protection at SW Studio, Vélez-Málaga

Your car. Our attention.

Ongoing care, not just
installation day.

The same technical care we apply when installing your protection carries through to every check-up: a prior assessment, the right product and a documented process.

We work with the CARPRO ceramic range and IMMORTAL PPF, both for installation and for its ongoing maintenance.

Tell us what protection you have

By appointment only
Vélez-Málaga · Costa del Sol
Every treatment traceable

From the first conversation

Care, with a defined plan.

01
Tell us what protection you have
Coating, PPF, or both, and when it was applied.
02
We check its real condition
We assess whether it needs decontamination, maintenance or renewal.
03
Restore its performance
We apply the right treatment and confirm your next check-up.

A little clarity

Before you decide.

How often should I maintain a ceramic coating?

It depends on the product and how the car is used, but we generally recommend a periodic check-up to preserve its properties.

Does PPF need maintenance too?

Yes. We check its clarity, adhesion and protective performance, and apply the treatments needed.

What is paint decontamination?

A technical process that removes iron particles, tree sap and tar bonded to the paint, leaving the surface ready for protection or maintenance.

Can you maintain protection you didn't install?

Yes. We assess the real condition of the existing treatment before recommending anything.

Do you work by appointment only?

Yes. We assess every car before defining the maintenance protocol.

SW Studio · Vélez-Málaga

Let's start by
checking your car.

Tell us what protection you have and when it was applied.
We'll tell you what your car needs now.

Enquire on WhatsApp Send an email

Calle Camino del Remanente, 16
29700 Vélez-Málaga, Málaga, Spain
+34 625 38 57 36

We welcome clients from Vélez-Málaga, Torre del Mar, Nerja, Rincón de la Victoria and the wider Axarquía.

Keep yourprotectionperforming.